GENERAL DESCRIPTION

The ADN4667 is a quad, CMOS, low voltage differential signaling (LVDS) line driver offering data rates of over 400 Mbps (200 MHz) and ultralow power consumption. It features a flow through pinout for easy PCB layout and separation of input and output signals.

The device accepts low voltage TTL/CMOS logic signals and converts them to a differential current output of typically ±3.1 mA for driving a transmission medium such as a twisted pair cable. The transmitted signal develops a differential voltage of typi-cally ±310 mV across a termination resistor at the receiving end. This is converted back to a TTL/CMOS logic level by an LVDS receiver, such as the ADN4668.

The ADN4667 also offers active high and active low enable/ disable inputs (EN and EN). These inputs control all four drivers and turn off the current outputs in the disabled state to reduce the quiescent power consumption to typically 10 mW.

The ADN4667 and its companion LVDS receiver, the ADN4668, offer a new solution to high speed, point-to-point data trans-mission, and a low power alternative to emitter-coupled logic ECL) or positive emitter-coupled logic (PECL).

FEATURES

±15 kV ESD protection on output pins

400 Mbps (200 MHz) switching rates

Flow through pinout simplifies PCB layout

300 ps typical differential skew

400 ps maximum differential skew

1.7 ns maximum propagation delay

3.3 V power supply

±310 mV differential signaling

Low power dissipation (10 mW typical)

Interoperable with existing 5 V LVDS receivers

High impedance on LVDS outputs on power-down

Conforms to TIA/EIA-644 LVDS standards

Industrial operating temperature range: −40°C to +85°C

Available in surface-mount (SOIC) and low profile

TSSOP package

Qualified for automotive applications

APPLICATIONS

Backplane data transmission

Cable data transmission

Clock distribution