Dual High Speed ECL Comparators

GENERAL DESCRIPTION The ADCMP563/ADCMP564 are high speed comparators fabricated on Analog Devices’ proprietary XFCB process. The devices feature a 700 ps propagation delay with less than 75 ps overdrive dispersion. Dispersion, a measure of the difference in propagation delay under differing overd

双路高速ECL比较器，采用16引脚QSOP封装

ADCMP563/ ADCMP564 均为高速比较器，采用ADI公司的专有XFCB工艺制造。这些器件的传播延迟为700 ps，过驱消散小于75 ps。消散是对不同过驱条件下传播延迟差异的量度，它是高速比较器的一个特别重要的特性。ADCMP564上提供单独的可编程迟滞引脚。\n\n 差分输入级使各种信号的传播延迟可以保持一致，共模范围为-2.0 V至+3.0 V。输出为互补数字信号，与ECL 10 K和10 KH逻辑系列完全兼容。这些输出提供充足的驱动电流，可直接驱动采用50 Ω电阻端接至−2 V的传输线路。上述器件还提供锁存输入，可采用跟踪、跟踪保持或采样保持工作模式。锁存输入引脚内 • 差分ECL兼容输出\n• 输入至输出传播延迟：700 ps\n• 传播延迟消散：75 ps\n• 输入共模范围：–2.0 V至+3.0 V\n• 鲁棒的输入保护\n• 差分锁存控制\n• 内部锁存上拉电阻\n• 电源抑制：> 85 dB\n• 脉冲宽度：700 ps（最小值）\n• 等效输入上升时间带宽：1.5 GHz\n• 典型输出上升/下降时间：500 ps\n• ESD保护> 4kV HBM >200V MM\n• 可编程迟滞;

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual High Speed ECL Comparators

GENERAL DESCRIPTION The ADCMP563/ADCMP564 are high speed comparators fabricated on Analog Devices’ proprietary XFCB process. The devices feature a 700 ps propagation delay with less than 75 ps overdrive dispersion. Dispersion, a measure of the difference in propagation delay under differing overd

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：221.37 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

Dual, High Speed ECL Comparators

文件：279.49 Kbytes Page：16 Pages

3.3V-Powered, EIA/TIA-562 Dual Transceiver with Receivers Active in Shutdown

General Description The MAX563 is a +3.3V-powered EIA/TIA-562 transceiver with two transmitters and two receivers. Because it implements the EIA/TIA-562 standard, the MAX563 communicates with RS-232 transceivers, yet consumes far less power; this makes it ideal for battery-powered, hand-held

3.3V-Powered, EIA/TIA-562 Dual Transceiver with Receivers Active in Shutdown

General Description The MAX563 is a +3.3V-powered EIA/TIA-562 transceiver with two transmitters and two receivers. Because it implements the EIA/TIA-562 standard, the MAX563 communicates with RS-232 transceivers, yet consumes far less power; this makes it ideal for battery-powered, hand-held

4-Bit Single-Chip Microcomputer(LCD Driver)

Two Channel Direct Drive Speech Controller?

INTRODUCTION SNC563 is a two-channel voice synthesizer IC with PWM direct drive circuit. It built-in a 4-bit tiny controller with one 4-bit input port and two 4-bit I/O ports. By programming through the tiny controller in SNC563, user’s varied applications including voice section combination, key

SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR

* 500W surge capability at 1ms * Excellent clamping capability * Low zener impedance * Fast response time : typically less then 1.0 ps from 0 volt to V BR(min.) * Typical IR less then 1mA above 10V