单电源、高速PECL比较器，采用8引脚MSOP封装

ADCMP551/ADCMP552/ADCMP553均为单电源、高速比较器，采用ADI公司的专有XFCB工艺制造。这些器件的传播延迟为750 ps，过驱消散小于150 ps。消散是对不同过驱条件下传播延迟差异的量度，它是高速比较器的一个特别重要的特性。ADCMP552上提供单独的可编程迟滞引脚。\n\n 差分输入级使传播延迟可以保持一致，共模范围为–0.2 V至VCCI – 2.0 V。输出为互补数字信号，与PECL 10 K和10 KH逻辑系列完全兼容。这些输出提供充足的驱动电流，可直接驱动采用50 Ω电阻端接至VCCO - 2 V的传输线路。上述器件还提供锁存输入，并可采用跟踪、 • 单电源\n\n• 输入至输出传播延迟：750 ps\n\n• 传播延迟消散：100 ps\n\n• 差分PECL兼容输出\n\n• 差分锁存控制;

Single Supply High Speed PECL Comparators

文件：522.03 Kbytes Page：14 Pages

Single-Supply, High Speed PECL/LVPECL Comparators

文件：358.21 Kbytes Page：16 Pages

Single Supply High Speed PECL/LVPECL Comparators

文件：259.79 Kbytes Page：16 Pages

Single Supply High Speed PECL Comparators

文件：522.03 Kbytes Page：14 Pages

Single-Supply, High Speed PECL/LVPECL Comparators

文件：358.21 Kbytes Page：16 Pages

Single Supply High Speed PECL/LVPECL Comparators

文件：259.79 Kbytes Page：16 Pages

PNP Silicon Digital Transistor (Switching circuit, inverter, interface circuit, driver circuit)

PNP Silicon Digital Transistor • Switching circuit, inverter, interface circuit, driver circuit • Built in bias resistor (R1=2.2kΩ, R2=2.2kΩ)

RF LOW POWER TRANSISTOR NPN SILICON

The RF Line NPN Silicon RF Low Power Transistor Designed primarily for wideband large signal predriver stages in the VHF frequency range. • Specified @ 12.5 V, 175 MHz Characteristics Output Power = 1.5 W Minimum Gain = 11.5 dB Efficiency 60 (Typ) • Cost Effective PowerMacro Packag

Schottky Barrier Diode

Description: The NTE553 is a silicon schottky barrier diode in a DO35 style package for use in UHF and VHF switching applications. Absolute Maximum Ratings: (TA = +25°C unless otherwise specified) Reverse Voltage, VR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Two Channel Direct Drive Speech Controller?

INTRODUCTION SNC553 is a two-channel voice synthesizer IC with PWM direct drive circuit. It built-in a 4-bit tiny controller with one 4-bit input port and two 4-bit I/O ports. By programming through the tiny controller in SNC553, user’s varied applications including voice section combination, key

CRT Display Video Output Amplifier

Features • Active load circuits • Wide bandwidth and high output voltage. Optimal for use in fH (horizontal deflection frequency) = 90 kHz class ultrahigh precision monitors. • Single 15-pin SIP molded package houses three channels.