JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

Precision, Dual-Channel Instrumentation Amplifier

GENERAL DESCRIPTION The AD8222 is a dual-channel, high performance instrumentation amplifier that requires only one external resistor per amplifier to set gains of 1 to 10,000. The AD8222 is the first dual-instrumentation amplifier in the small 4 mm × 4mm LFCSP. It requires the same board area a

Low Noise, Low Gain Drift, G = 2000 Instrumentation Amplifier

GENERAL DESCRIPTION The AD8428 is an ultralow noise instrumentation amplifier designed to accurately measure tiny, high speed signals. It delivers industry-leading gain accuracy, noise, and bandwidth. All gain setting resistors for the AD8428 are internal to the part and are precisely matched. C

Wide Supply Range, Rail-to-Rail Output Instrumentation Amplifier

GENERAL DESCRIPTION The AD8426 is a dual-channel, low cost, wide supply range instrumentation amplifier that requires only one external resistor to set any gain from 1 to 1000. The AD8426 is designed to work with a variety of signal voltages. A wide input range and rail-to-rail output allow the

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

具有轨到轨输出的JFET输入仪表放大器

AD8220是第一款单电源、JFET输入仪表放大器，采用MSOP封装。它针对高性能、便携式仪器的需要而设计，直流时的最小共模抑制比（CMRR）为86 dB，在5 kHz、G = 1时的最小CMRR为80 dB。最大输入偏置电流为10 pA，在整个工业温度范围内通常保持在300 pA以下。虽然采用JFET输入，但AD8220的噪声转折频率典型值仅为10 Hz。 \n\n 随着混合信号处理技术日益普及，各系统所需的电源数量也不断增加。AD8220正是为缓解这一问题而设计。它既可以采用±18 V双电源供电，也可以采用+5 V单电源供电。在便携式应用中常见的低电源电压下，其轨到轨输出级可以使 • 高共模抑制比(CMRR)\n• CMRR：100 dB（最小值，G = 10，B级）\n\n• CMRR：80 dB（最小值，至5 kHz，G = 1，B级）\n\n\n\n\n• 出色的交流特性、低功耗\n• 带宽：1.5 MHz (G = 1)\n\n• 输入噪声：14 nV/√Hz （1 kHz）\n\n• 压摆率：2 V/μs\n\n• 静态电源电流：750 μA（最大值）\n\n\n\n\n\nAD8220-EP支持防务和航空航天应用（AQEC标准）\n• 下载AD8220-EP数据手册(pdf)\n\n• 军用温度范围（−55℃至+125℃）\n\n• 受控制造基线\n\n• ;

Zero Drift, Digitally Programmable Instrumentation Amplifier

文件：725.71 Kbytes Page：24 Pages

Low Cost Low Power Instrumentation Amplifier

文件：483.17 Kbytes Page：21 Pages

Wide Supply Range, Micropower,

文件：529.22 Kbytes Page：28 Pages

Wide Supply Range, Rail-to-Rail

文件：805.88 Kbytes Page：28 Pages

JFET Input Instrumentation Amplifier

文件：530.31 Kbytes Page：28 Pages

Low Noise, Low Gain Drift, G = 2000

文件：361.17 Kbytes Page：20 Pages

10 MHz, 20 V/關s, G = 1, 10, 100, 1000 i CMOS짰 Programmable Gain Instrumentation Amplifier

GENERAL DESCRIPTION The AD8253 is an instrumentation amplifier with digitally programmable gains that has GΩ input impedance, low output noise, and low distortion making it suitable for interfacing with sensors and driving high sample rate analog-to-digital converters (ADCs). It has high bandwidt

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

GENERAL DESCRIPTION The AD8220 is the first single-supply JFET input instrumentation amplifier available in an MSOP package. Designed to meet the needs of high performance, portable instrumentation, the AD8220 has a minimum common-mode rejection ratio (CMRR) of 86 dB at dc and a minimum CMRR of

JFET Input Instrumentation Amplifier

文件：530.31 Kbytes Page：28 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package

文件：610.24 Kbytes Page：29 Pages

Silicon planar type

Silicon planar type For stabilization of power supply ■Features •Extremely low noise voltage caused from the diode (2.4V to 39V, 1/3 to 1/10 of our conventional MAZ3000 series) •Extremely good rising performance (in the low-current range) •Easy-to-select the optimum diode because

Silicon planar type

Silicon planar type For stabilization of power supply ■Features •Extremely low noise voltage caused from the diode (2.4V to 39V, 1/3 to 1/10 of our conventional MAZ3000 series) •Extremely good rising performance (in the low-current range) •Easy-to-select the optimum diode because

Silicon planar type

Silicon planar type For stabilization of power supply ■Features •Extremely low noise voltage caused from the diode (2.4V to 39V, 1/3 to 1/10 of our conventional MAZ3000 series) •Extremely good rising performance (in the low-current range) •Easy-to-select the optimum diode because

Silicon planar type

Silicon planar type For stabilization of power supply ■Features •Extremely low noise voltage caused from the diode (2.4V to 39V, 1/3 to 1/10 of our conventional MAZ3000 series) •Extremely good rising performance (in the low-current range) •Easy-to-select the optimum diode because

Calling Number Identification Receiver IC

The SM8220/SM8221 Calling Number Identification Receiver IC is a CMOS integrated circuit, which provides an interface to various calling information delivery services such as Calling Number Delivery (CND) and Calling Name Delivery (CNAM) compatible with the Bellcore GR-30-CORE. The device also con