20 STERN AVE. SPRINGFIELD, NEW JERSEY 07081

文件：136.38 Kbytes Page：2 Pages

Automotive Half-Bridge MOSFET Driver

The A4927 is an N-channel power MOSFET driver capable of controlling MOSFETs connected in a half-bridge arrangement and is specifically designed for automotive applications with high-power inductive loads, such as brush DC motors solenoids and actuators.\n\n The A4927 is intended for automotive \n• Bootstrap gate drive for N-channel MOSFET bridge\n• Charge pump regulator for low supply voltage operation\n• SPI-compatible serial interface\n• Programmable gate drive\n• Programmable diagnostics\n• A2SIL™ product—device features for safety-critical systems;

汽车半桥 MOSFET 驱动器

A4928 是一款可以控制以半桥式设置连接的 MOSFET 的 N 通道功率 MOSFET 驱动器，特别针对使用大功率电感负载（如：直流电刷电机电磁阀、执行器、燃油泵和集成启动机-发电机系统）的汽车应用而设计。 A4928 适用于采用 5V 微处理器的ASIL 认证汽车系统。 输入阈值可兼容 5V CMOS 逻辑电路。该器件与其他 Allegro A2SIL™ 产品相同，包括促成正确的系统设计的功能，允许用户达到所需的 ASIL 等级。 独特的电荷泵稳压器提供完整门极驱动器，以应对电池电压低至 5.5V 的大部分应用。自举电容器用于提供 N 通道 MOSFET 需要的上述电池电源电压。\n\ • 半桥 MOSFET 驱动器\n • 用于 N 通道 MOSFET 桥的自举栅极驱动\n • 通过可调节无感时间进行交叉传导保护\n • 低电源电压下运行的电荷泵稳压器\n • 5.5 至 50V 电源电压运行范围\n • 5 V CMOS 逻辑 I/O\n • SPI 兼容串行接口\n • 通过直接逻辑输入或串行接口进行桥控制\n • 可编程栅极驱动\n • 电流感应放大器\n • 可编程诊断\n • 通过 AEC-Q100 汽车电子测试标准的认证\n • A2SIL™ 产品—器件专为安全性至关重要的系统而打造;

3-Phase Sinusoidal Motor Controller

文件：536.27 Kbytes Page：11 Pages

3-Phase Sinusoidal Motor Controller

文件：536.27 Kbytes Page：11 Pages

封装/外壳：32-VFQFN 裸露焊盘 功能：控制器 - 换向，方向管理 包装：管件 描述：IC MOTOR DRIVER 2V-5.5V 32QFN 集成电路（IC） 电机驱动器，控制器

封装/外壳：32-VFQFN 裸露焊盘 功能：控制器 - 换向，方向管理 包装：管件 描述：IC MOTOR DRIVER 2V-5.5V 32QFN 集成电路（IC） 电机驱动器，控制器

3-Phase Sinusoidal Motor Controller

文件：536.27 Kbytes Page：11 Pages

Automotive Half-Bridge MOSFET Driver

文件：785.45 Kbytes Page：36 Pages

Automotive Half-Bridge MOSFET Driver

文件：785.45 Kbytes Page：36 Pages

Automotive Half-Bridge MOSFET Driver

文件：857.57 Kbytes Page：40 Pages

Automotive Half-Bridge MOSFET Driver

文件：857.57 Kbytes Page：40 Pages

Automotive Half-Bridge MOSFET Driver

文件：1.39916 Mbytes Page：41 Pages

Automotive Half-Bridge MOSFET Driver

文件：1.39916 Mbytes Page：41 Pages

RF POWER TRANSISTOR NPN SILICON

The RF Line NPN Silicon RF Power Transistor Designed for 12.5 volt low band VHF large–signal power amplifier applications in commercial and industrial FM equipment. • Specified 12.5 V, 50 MHz Characteristics — Output Power = 70 W Minimum Gain = 11 dB Efficiency = 50 • Load Mismatc

DUAL/QUAD SINGLE SUPPLY OPERATIONAL AMPLIFIER

GENERAL DESCRIPTION The OP292/OP492 are low cost, general purpose dual and quad operational amplifiers designed for single-supply applications and are ideal for +5 olt systems. FEATURES Single-Supply Operation: 4.5 V to 33 V Input Common-Mode Includes Ground Output Swings to Ground

DUAL/QUAD SINGLE SUPPLY OPERATIONAL AMPLIFIER

GENERAL DESCRIPTION The OP292/OP492 are low cost, general purpose dual and quad operational amplifiers designed for single-supply applications and are ideal for +5 olt systems. FEATURES Single-Supply Operation: 4.5 V to 33 V Input Common-Mode Includes Ground Output Swings to Ground

0.39 INCH (9.9MM) SINGLE DIGIT STICK DISPLAY

文件：223.54 Kbytes Page：6 Pages

MOSFET N-Ch, Enhancement Mode High Speed Switch

文件：21.64 Kbytes Page：2 Pages